Ford Explorer: Maintenance / Checking the Wiper Blades & Changing the Front Wiper Blades

Run the tip of your fingers over the edge of the blade to check for roughness.
Clean the wiper blades with washer fluid or water applied with a soft sponge
or cloth.
https://magicaliptv.com/iptv-free-trials/ Changing the Front Wiper Blades
You can improve poor wiper quality by cleaning the wiper blades and the windshield.
Replace the wiper blades at least annually for optimum performance.

- Lift the wiper arm and then press the wiper blade locking buttons together.
Note: Do not hold the wiper blade to lift the wiper arm.
Note: Make sure that the wiper arm does not spring back against the
glass when the wiper blade is not attached.
- Slightly rotate the wiper blade.
- Remove the wiper blade.
- To install, reverse the removal procedure.
Note: Make sure that the wiper blade locks into place.
WARNING: Batteries normally produce explosive gases which can cause personal
injury. Therefore, do not allow flames, sparks or lighted substances to come near
the battery...
You can improve poor wiper quality by cleaning the wiper blades and the windshield.
Replace the wiper blades at least annually for optimum performance...
Other information:
Removal
Remove the hood latch release handle.
Rotate the hood latch release handle.
NOTE:
Do not remove the retaining clip from the hood latch release handle.
Release the retaining clip.
Remove the hood latch release handle...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH is similar.
Lower the headliner.
Refer to: Headliner - Lowering (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Categories
The front outboard and rear safety restraints in the vehicle are combination
lap and shoulder belts.

read more