Ford Explorer: Roof Opening Panel / Removal and Installation - Roof Opening Panel Control Switch
Removal
-
The roof opening panel switch is replaced as an assembly with the overhead console.
Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation).
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the roof opening panel fixed glass.
Refer to: Roof Opening Panel Fixed Glass (501-17 Roof Opening ..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the roof opening panel frame.
Refer to: Roof Opening Panel Frame (501-17 Roof Opening Panel, Remov..
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the RH loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Disconnect the electrical connector...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
Remove the sunload sensor from the instrument panel.
Disconnect the electrical connector.
Use the General Equipment: Interior Trim Remover
Installation
To install, reverse the removal procedure...
Categories
When these locks are set, you cannot open the rear doors from the inside.

A child safety lock is on the rear edge of each rear door. You must set the child
safety lock separately on each door.
Left-Hand Side
read more