Ford Explorer: Adaptive Cruise Control / Setting the Adaptive Cruise Control Speed

Ford Explorer 2020-2024 Owners Manual / Adaptive Cruise Control / Setting the Adaptive Cruise Control Speed

Drive to the speed you prefer.

Press the toggle button upward or downward to set the current speed.

Мелбет онлайн

Take your foot off the accelerator pedal.

The indicator, current gap setting and set speed appear in the information display.

A vehicle image illuminates if there is a vehicle detected in front of you.

Note: When adaptive cruise control is active, the speedometer may vary slightly from the set speed displayed in the information display.

Setting the Adaptive Cruise Speed from a Complete Stop

Press the toggle button upward or downward while keeping the brake pedal fully pressed.

The set speed adjusts to 20 mph (30 km/h).

The indicator, current gap setting and set speed appear in the information display.

Manually Changing the Set Speed

Press and release the toggle button upward to increase the set speed in small increments.

Press and hold the toggle button upward to increase the set speed in large increments. Release the button when you reach the speed you prefer.

Press and release the toggle button downward to decrease the set speed in small increments.

Press and hold the toggle button downward to decrease the set speed in large increments. Release the button when you reach the speed you prefer.

Press the accelerator or brake pedal until you reach the speed you prefer. Press the toggle button upward or downward to select the current speed as the set speed.

The system may apply the brakes to slow the vehicle to the new set speed. The set speed displays continuously in the information display when the system is active.

    Switching Adaptive Cruise Control On and Off

    The cruise controls are on the steering wheel. See Cruise Control. Switching Adaptive Cruise Control On Press to set the system in standby mode. The indicator, current gap setting and set speed ..

    Setting the Adaptive Cruise Control Gap

    Press the button to cycle through the four gap settings. The selected gap appears in the information display as shown by the bars in the image...

    Other information:

    Ford Explorer 2020-2024 Service Manual: General Procedures - Supplemental Restraint System (SRS) Depowering


    Depower   WARNING: Incorrect repair techniques or actions can cause an accidental Supplemental Restraint System (SRS) deployment. Never compromise or depart from these instructions. Failure to precisely follow all instructions could result in serious personal injury from an accidental deployment...

    Ford Explorer 2020-2024 Service Manual: General Procedures - Bezel Diagnostics


    Check NOTE: If there is a concern with one of the following components and Bezel Diagnostics cannot be accessed, obtain the module part number by referencing the label attached to the module. Inoperative ACM Inoperative (blank or does not power on) display unit (non-touchscreen display or touchscreen display) Inoperative FCIM or radio control panel Inoperative steering w..

    Categories

    Seatbelt Height Adjustment

    WARNING: Position the seatbelt height adjuster so that the seatbelt rests across the middle of your shoulder. Failure to adjust the seatbelt correctly could reduce its effectiveness and increase the risk of injury in a crash.

    read more

     
    Copyright © 2024 www.foexplorer.com