Ford Explorer: Perimeter Anti-Theft Alarm / Description and Operation - Perimeter Anti-Theft Alarm - Component Location
| Item |
Description |
| 1 |
Hood latch (with integrated hood ajar switch) |
| 2 |
BCM
|
Overview
The perimeter anti-theft alarm system has three operation modes:
ARMED - The perimeter anti-theft alarm is armed when the
ignition is OFF and all vehicle entry points have been electr..
Other information:
Check
NOTE:
If there is a concern with one of the following components
and Bezel Diagnostics cannot be accessed, obtain the module part number
by referencing the label attached to the module.
Inoperative ACM
Inoperative (blank or does not power on) display unit (non-touchscreen display or touchscreen display)
Inoperative FCIM or radio control panel
Inoperative steering w..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH (left hand) shown, RH (right hand) similar.
Remove the second row single seat backrest cover.
Refer to: Second Row Single Seat Backrest Cover - Vehicles With: Second Row Captain Chairs (501-10B Second Row Seats, Removal and Installation)...
Categories
WARNING: Position the seatbelt height adjuster so that the seatbelt rests
across the middle of your shoulder. Failure to adjust the seatbelt correctly could
reduce its effectiveness and increase the risk of injury in a crash.

read more