Kia Picanto: Engine System - General Information / General Procedures - Valve Stem Diameter
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
-
Measure the diameter of each intake and exhaust valve
stem at the points shown. Verify the diameter is within specification.
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Valve guides tend to wear in an hourglass pattern.
The ball gauge can be inserted into the combustion ..
Other information:
Repair
NOTE:
Mouldings located on the front and rear window frames may
experience minor scratches from vehicle shipment or car wash racks. The
imperfections may be repaired instead of replacing components by
following the steps below.
NOTE:
Scratches deep enough to cause a thumb nail to catch cannot be repaired and the component must be replaced...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Detach the windshield washer hose coupling.
Detach the windshield washer hose pin-type retainers from the hood hinge.
On both sides...
Categories
When these locks are set, you cannot open the rear doors from the inside.

A child safety lock is on the rear edge of each rear door. You must set the child
safety lock separately on each door.
Left-Hand Side
read more