Ford Explorer: Wipers and Washers / Removal and Installation - Windshield Washer Pump

Ford Explorer 2020-2025 Service Manual / Body and Paint / Body and Paint / Wipers and Washers / Removal and Installation - Windshield Washer Pump

Materials

Name	Specification
Motorcraft® Premium Windshield Wash Concentrate with Bitterant ZC-32-B2	WSS-M14P19-A

Removal

Remove the windshield washer reservoir.
Refer to: Windshield Washer Reservoir (501-16 Wipers and Washers, Removal and Installation).

1. Disconnect the windshield washer pump electrical connector.
1. Disconnect the windshield washer pump fluid hoses.
1. Remove the windshield washer pump.

Installation

NOTICE: Do not operate the washer pump prior to filling the windshield washer reservoir. Failure to follow this instruction may result in premature pump failure.
To install, reverse the removal procedure.
Material: Motorcraft® Premium Windshield Wash Concentrate with Bitterant / ZC-32-B2 (WSS-M14P19-A)

Removal and Installation - Windshield Washer Fluid Level Sensor

Special Tool(s) / General Equipment Fluid Suction Gun Fluid Container Materials Name Specification Motorcraft® Premium Windshield Wash Concentrate with BitterantZC-32-B2 WSS-M..

Removal and Installation - Windshield Washer Reservoir

Special Tool(s) / General Equipment Fluid Suction Gun Fluid Container Materials Name Specification Motorcraft® Premium Windshield Wash Concentrate with BitterantZC-32-B2 WSS-M..

Other information:

Ford Explorer 2020-2025 Owners Manual: Capacities and Specifications - 2.3L EcoBoost™

Use oil and fluid that meets the defined specification and viscosity grade. If you do not use oil and fluid that meets the defined specification and viscosity grade, it could result in: Component damage not covered by the vehicle warranty. Longer engine cranking periods...

Ford Explorer 2020-2025 Service Manual: General Procedures - Piston Ring End Gap

Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Use care when fitting piston rings to avoid possible damage to the piston ring or the cylinder bore...