Ford Explorer: Glass, Frames and Mechanisms / Removal and Installation - Rear Door Window Glass
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
-
Remove the rear door glass top run.
Refer to: Rear Door Glass Top Run (501-11 Glass, Frames and Mechanisms, Removal and Installation).
-
Remove the rear door window glass.
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
Remove the rear door window control switch..
Special Tool(s) /
General Equipment
Punch
Removal
NOTE:
Left hand (LH) shown, right hand (RH) similar.
NOTE:
For rear door window regulator motors that are
non-functional it will b..
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH lamps shown, RH lamps similar.
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
Cut the tie strap, disconnect the electrical connector,
remove the nuts and the flashing light emitting diode (LED) lamp...
Removal
NOTE:
The maximum articulation of the flex coupling is 4 degrees.
The maximum articulation of any U-joint is 25 degrees. The maximum
articulation of the center CV-joint is 20 degrees. The maximum
articulation of the rear axle CV-joint is 15 degrees...
Categories
Use the key blade to start your vehicle and unlock or lock the driver door from
outside your vehicle. The integrated keyhead transmitter functions as a programmed
ignition key that operates all the locks and starts your vehicle, as well as a remote
control.
read more